Powershell: Convert a string into a securestring and back to plaintext

Hi,

.Net and therefore the powershell has the ability to define a secure string. This means that the string is immediately deleted from memory if it is no longer needed.
Continue reading Powershell: Convert a string into a securestring and back to plaintext

Advertisment to support michlstechblog.info

Raspberry Pi: serial console

Hi,

most linux distributions for Raspberry Pi activating a serial console.

With USB to UART (TTL) convert connected you can observe the boot messages and usually get a text terminal when boot has finished.

The Wiring. The Raspberry GPIO Pins

GND UART0 TX UART0 RX
Pin 6 Pin 8 (GPIO 14) Pin 8 (GPIO 15)

Connect the Converter GND to Raspberry GND and cross RX and TX pins => TX Pin Converter to RX Pin Raspberry and RX Pin Converter to TX Pin Raspberry.

USB 2 UART

Open a console session. BAUDRATE is 115200.

For Windows use PuTTY.

Connect your USB to UART converter and determine the COM port by the device manager.

USB2UART DeviceManager

Open PuTTY, set Baudrate and COM port

PuTTY serial setup COM Port

Set detailed properties, especially the flow control must set to NONE

PuTTY serial setup properties

Then press open.

Under linux you can use minicom or screen. Note: A non root user must be member of the group dialout to access a serial device

root@devdeb ~ # 
ls -l /dev/ttyACM0
crw-rw----+ 1 root dialout 166, 0 Jan 27 15:48 /dev/ttyACM0 

With minicom

root@devdeb ~ # minicom -b 115200 -D /dev/ttyACM0

or screen. Here a boot:

root@devdeb ~ # screen /dev/ttyACM0 115200
[    4.039301] Indeed it is in host mode hprt0 = 00021501
[    4.144675] mmc0: host does not support reading read-only switch, assuming write-enable
[    4.162274] mmc0: new high speed SDHC card at address 5048
[    4.173141] mmcblk0: mmc0:5048 SD32G 28.9 GiB
[    4.185397]  mmcblk0: p1 p2
[    4.238110] EXT4-fs (mmcblk0p2): mounted filesystem with ordered data mode. Opts: (null)
[    4.253134] usb 1-1: new high-speed USB device number 2 using dwc_otg
[    4.263466] Indeed it is in host mode hprt0 = 00001101
[    4.332576] VFS: Mounted root (ext4 filesystem) readonly on device 179:2.
[    4.353333] devtmpfs: mounted
[    4.366723] Freeing unused kernel memory: 512K
[    4.374927] This architecture does not have kernel memory protection.
[    4.385117] Run /sbin/init as init process

Michael

My Knowledgebase for things about Linux, Windows, VMware, Electronic and so on…

Exit mobile version