Hi,
as an alternative to knxd the calimero project also supplies an KNXnet/IP server.
Continue reading EIB/KNX: KNXNet/IP Gateway with calimero server on Raspberry Pi/Orange Pi PC
Hi,
as an alternative to knxd the calimero project also supplies an KNXnet/IP server.
Continue reading EIB/KNX: KNXNet/IP Gateway with calimero server on Raspberry Pi/Orange Pi PC
Hi,
in my previous posts EIB/KNX Router with an USB Interface and KNX/EIB Router with a TPUART module I described how to use a Raspberry PI as EIB/KNX Router with eibd.
eibd is no longer in development so I decided to give knxd, a fork of eibd, a try:-) The script attached at the end of the post is written for raspbian but should also work an all debian system with systemd imit system.
Continue reading Raspberry Pi: EIB/KNX IP Gateway and Router with knxd
Hi,
a reader of my post asks me if it possible to connect the eibd bus with a KNX USB Interface instead of the TPUART board. These interfaces are available by several vendors(Siemens, Gira, Merten etc.).
I have no KNX USB Interface for testing and therefore Bastian Herzog did that part and supports me to improve the script. Very special thanks to him. Together we have get this started.
As descripted in the previous post setup your Raspberry Pi with raspbian:
Continue reading Raspberry Pi: eibd with a KNX USB Interface
Hi,
this Post is a tutorial to build an IP EIB/KNX Gateway based on a Raspberry Pi completely from the scratch. The core components are the eib daemon from the bcusdk in conjunction with the TPUART EIB Bustranceiver module.
The Hardware
3 components are needed:
You can use A or the B Model of Raspberry Pi. The eibd daemon has minimal hardware requirements.
There are two possibilities for connecting a computer to the EIB/KNX Bus over a RS232 serial interface. Both are supported by eibd.
Continue reading Raspberry PI: EIB/KNX IP Gateway and Router