this is the list of my the frequently fabric commands:
Uptime of the switch
Date / Time
Fabric OS version
Switch state with hardware overview
Good overview of the switch with ports…
Show domain ID
Set the fabricname
Continue reading Brocade: My often used FabricOS commands →
Advertisment to support michlstechblog.info
these are my FAQs for Tasmota:
Continue reading Tasmota: My FAQs →
short post today. It shows howto configure a GPIO Pin as PWM with a width of 1024Bits. Note the restrictions when using IO Ports.
Configure GPIO 14 to PWM 1.
Continue reading Tasmota: Setup a PWM with 1024Bit →
I already owned a HD44780 I2C Display, which is compatible to LCDd/lcdproc, and want to get this running with Tasmota.
Problem: The LCD 2004 or LCD 1602 Display, for which the Tasmota LCD driver was written, uses a different wiring between the i2c expander (PCF8574) and the HD44780 Display.
Continue reading Tasmota: Connect a lcdproc/LCDd compatible HD44780 i2c Display →
these steps describes how to install Tasmota on Sonoff Smart Home WIFI/WLAN relay.
First you need a the flash tool esptool. Simplest way is to install the python module. This is the same way on linux and windows
Continue reading Sonoff TH10/16: Flashing Tasmota and setup temperature measurement →